Results 1 to 6 of 6

Thread: Help!!!

  1. #1
    Senior Member
    Join Date
    May 2014
    Location
    New Jersey
    Posts
    382

    Help!!!

    Ok so my older 7D has been suddenly giving me "Err 30. Shooting not possible due to error"
    The usual troubleshooting didn't work (remove battery, CF Card, Lens etc) Im guessing the shutter may need to be replaced.
    Anyone have this issue? Shed some light on this? Is it worth replacing the shutter?
    Thanks in advance!

  2. #2
    Super Moderator Kayaker72's Avatar
    Join Date
    Dec 2008
    Location
    New Hampshire, USA
    Posts
    5,665
    Never had the issue. Reading on the web, err 30 is the shutter being stuck. Sounds like there are a couple DYI fixes, but the problem tends to reoccur. I think you are looking at a call to Canon and likely taking in. Of course you can ship, or take it into Canon. I don't think you are too far from their Jamesburg, NJ location.

  3. #3
    Senior Member
    Join Date
    Dec 2008
    Location
    Ottawa, ON
    Posts
    1,466
    Bummer.

    If you plan to keep and use the 7D for few more years, then it makes sense to send it in.

    If you were already planning an upgrade soon, then you need to consider the cost of the repair vs. the price you can get for it when sold. If the difference is small, it may be simpler to accept it as a write-off, and a sooner than expected upgrade, rather than deal with all the hassles of selling used gear. A replaced shutter may increase it's used value to some potential buyers, while the fact that it needed to be sent in for a repair might scare off other potential buyers... you have a "known defective unit" in their eyes. I ran into this when selling a Canon XL1S camcorder.
    On Flickr - Namethatnobodyelsetook on Flickr
    R8 | R7 | 7DII | 10-18mm STM | 24-70mm f/4L | Sigma 35mm f/1.4 | 50mm f/1.8 | 85mm f/1.8 | 70-300mm f/4-5.6L | RF 100-500mm f/4-5-7.1L

  4. #4
    Senior Member
    Join Date
    May 2014
    Location
    New Jersey
    Posts
    382
    My other concern is I recently purchased a used 35mm f2. This issue began shortly after. Could a defect in the lens have fried my 7D? I have another 7D and Im leary about using the 35 on it.

  5. #5
    Senior Member clemmb's Avatar
    Join Date
    Dec 2008
    Location
    Bryan, TX
    Posts
    1,360
    I had a similar issue with my 5D. Had to send it in for repair. I suspect it was because I had the bad habit of making lense changes with power on.
    Mark

  6. #6
    Senior Member
    Join Date
    May 2014
    Location
    New Jersey
    Posts
    382
    Canon is replacing the shutter. $350

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •