Results 1 to 3 of 3

Thread: Canon 1D X LP-E4N Battery Calibration.

  1. #1
    Senior Member
    Join Date
    Dec 2008
    Location
    Anaheim, CA
    Posts
    741

    Canon 1D X LP-E4N Battery Calibration.

    Hi everyone,

    I have two Canon LP-E4N batteries for my 1D X, I calibrated them whenever I got the recommended message, one of them started to show the "calibration message" even after I did the calibration. Does any one know how I can get rid of that message, and how important is calibration? My 1D X is 4 years old, with very low mileage about 15000 clicks and I alternate between the two batteries and both of them still have 3 bar performance level with no drop on battery performance.

    Thanks,
    Nate

  2. #2
    Senior Member Jonathan Huyer's Avatar
    Join Date
    Dec 2008
    Location
    Canmore, Alberta
    Posts
    1,263
    Hi Nate -
    I used to get calibration messages when I owned the original 1DX as well. So far it hasn't happened with my new 1DX II. However when I did the calibration, the message always went away. So I'm not sure what might be happening in your case. The only issue I can see would be if the charger does not let you recharge the battery without doing the calibration. That is annoying because the calibration can take quite a while. If you can recharge without calibrating, then I'd just ignore the message.

  3. #3
    Senior Member
    Join Date
    Dec 2008
    Location
    Anaheim, CA
    Posts
    741
    Thank you Jonathan,

    I read others with the same problem let their batteries run out completely in camera (something I've never done) before they do the calibration and after calibration the message went away. I'm going to try that. If that doesn't work, I'll just ignore it, the battery recharge performance still has 3 green bars and I haven't noticed any drop in performance.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •