Results 1 to 4 of 4

Thread: TTL and subject distance

  1. #1
    Senior Member iND's Avatar
    Join Date
    Dec 2008
    Location
    ST LOUIS
    Posts
    400

    TTL and subject distance

    Since I have always used Manual settings for my flashes I have never thought much about TTL.

    My thought process is if I use a single focus point on my subject and the meter uses the entire scene or portion (as set in metering),

    Is there any compensation in the resulting flash power (duration) for distance to subject.

    A focus point should be able to determine distance with at least some accuracy.

    So if my subject is 5 feet or 15 feet or 25 feet away, realizing flash fall off, does the TTL factor this in?

    Thank you

  2. #2
    Senior Member
    Join Date
    Dec 2008
    Location
    Ottawa, ON
    Posts
    1,443
    (I think...) It first determines the exposure at ambient. Next, it does a very low-powered pre-flash, and determines how much effect that had on the exposure, compared to the ambient only exposure. Then, based on how much effect that low-powered pre-flash had, it can figure out the power needed for the main flash burst. So, not only will it be correct for the distance, but for the way a particular material reflects back the light...
    On Flickr - Namethatnobodyelsetook on Flickr
    R8 | R7 | 7DII | 10-18mm STM | 24-70mm f/4L | Sigma 35mm f/1.4 | 50mm f/1.8 | 85mm f/1.8 | 70-300mm f/4-5.6L | RF 100-500mm f/4-5-7.1L

  3. #3
    Senior Member conropl's Avatar
    Join Date
    Dec 2008
    Location
    West Michigan
    Posts
    1,466
    As Dave said the preflash does help achieve the same thing, but Canon incorporated distance data into the process with eTTL II. This increases the effectivness of the preflash by also using distance information as long as the lens is capable of communicating that information (not something a manual focus lens will do).
    Last edited by conropl; 07-24-2015 at 10:59 PM.
    5DS R, 1D X, 7D, Sigma 10-20mm f/4-5.6, 24mm f/1.4L II, 16-35mm f/4L IS, 24-105mm f/4L, 50mm f/1.8, 100mm Macro f/2.8L, 70-200mm f/2.8L IS II, 100-400mm f/4.5-5.6L, 580EX-II
    flickr

  4. #4
    Senior Member iND's Avatar
    Join Date
    Dec 2008
    Location
    ST LOUIS
    Posts
    400
    Found this from Bob Adkins

    The Canon EOS E-TTL II Flash System

    With the announcement of "E-TTL II".

    There is a new flash algorithm, similar to the existing E-TTL, but designed to give better results under difficult situations, such as when there is a very bright reflection from a small object in the scene.

    Just like E-TTL there is a preflash which is used, along with ambient light metering, to determine the flash exposure using the center 17 metering zones. Zones which differ greatly in brightness are given less weight since they are likely to be reflections from small, highly reflective, objects.

    With lenses which return distance information, this may also be taken into account by the flash algorithm, but the point to note here is that the E-TTL II system works with ALL Canon lenses, it's just that those which return distance information provide an additional parameter for flash calculation. Even without distance information ETTL II should provide better results in difficult situations. So all your lenses will work just fine with E-TTL II, it's just that under some circumstances, E-TTL II compatible lenses might give slightly better exposure when using shoe mounted on-camera direct flash.

    In general, if a lens uses a ring type USM motor, it returns distance information and so is E-TTL II compatible. Not all USM lenses use ring USM motors. Those which do not offer full time manual focus ( e.g. the Canon EF75-300/4-5.6 USM), do not return distance information. Lenses using AFM (arc form motors) do not return distance information (e.g. 50/1.8, 24/2.8).
    Notable lenses which you might think would return distance info but don't are the 50/1.4 USM and the 85/1.2L USM. The tilt-shift (T/S) lenses are manual focus, and so of course do not supply distance information.

    Non-current lenses which should return distance info include the non-IS telephoto lenses such as the EF 500/4.5L USM, 300/2.8L USM, 600/4L USM

    Note that E-TTL II does not use distance information when a direct, camera mounted, flash is not used, even with E-TTL II compatible lenses. These situations include:

    • When bounce flash is used
    • With ETTL wireless flash
    • With macro flash

    The reason for this is presumably that under those circumstance the flash-to-subject distance will be different from the camera-to-subject distance (which is the information that the lens returns), so the camera cannot know the flash-to-subject distance - and that is the information it would need to fine tune the E-TTL II algorithm results. The bottom line seems to be that the new E-TTL II flash algorithm will give better results with all lenses, but if your current lens isn't E-TTL II compatible, it's no big deal. You'll still get better results than you would with the older E-TTL system.

    Here is a list of current Canon EF series lenses which fully support E-TTL II by supplying distance information. It was updated on 03/04/2004 based on information supplied by Chuck Westfall of Canon

    Fixed Focal Length
    EF14mm f/2.8L USM
    EF20mm f/2.8 USM
    EF24mm f/1.4L USM
    EF28mm f/1.8 USM
    EF35mm f/1.4L USM
    MP-E65mm f/2.8 1-5x Macrophoto
    EF85mm f/1.8 USM
    EF100mm f/2 USM
    EF100mm f/2.8 Macro USM
    EF100mm f/2.8 Macro*
    EF135mm f/2L USM
    EF180mm f/3.5L Macro USM
    EF200mm f/2.8L II USM
    EF200mm f/2.8L USM*
    EF300mm f/2.8L IS USM
    EF300mm f/4L IS USM
    EF300mm f/4L USM*
    EF400mm f/2.8L IS USM
    EF400mm f/4 DO IS USM
    EF400mm f/5.6L USM
    EF500mm f/4L IS USM
    EF600mm f/4L IS USM
    EF1200mm f/5.6L USM
    Zoom Lenses
    EF16-35mm f/2.8L USM
    EF17-35mm f/2.8L USM*
    EF17-40mm f/4L USM
    EF20-35mm f/3.5-4.5 USM
    EF24-70mm f/2.8L USM
    EF24-85mm f/3.5-4.5 USM
    EF28-70mm f/2.8L USM*
    EF28-80mm f/3.5-5.6 USM*
    EF28-105mm f/3.5-4.5 II USM
    EF28-105mm f/3.5-4.5 USM*
    EF28-105mm f/4-5.6 USM
    EF28-105mm f/4-5.6
    EF28-200mm f/3.5-5.6 USM
    EF28-200mm f/3.5-5.6*
    EF28-300mm f/3.5-5.6L IS USM
    EF35-135mm f/4-5.6 USM*
    EF70-200mm f/2.8L IS USM
    EF70-200mm f/2.8L USM
    EF70-200mm f/4L USM
    EF70-210mm f/3.5-4.5 USM*
    EF70-300mm f/4.5-5.6 DO IS USM
    EF90-300mm f/4.5-5.6 USM
    EF90-300mm f/4.5-5.6
    EF100-300mm f/4.5-5.6 USM
    EF100-400mm f/4.5-5.6L IS USM
    EF-S18-55mm f/3.5-5.6 USM
    EF-S18-55mm f/3.5-5.6
    *Indicates discontinued product

    If your Canon EF lens doesn't show up on this list, it does not feed distance data back to the camera through the electronic mount.

    As a reminder, distance data is never the only factor that controls flash exposure in E-TTL II. It is an optional data point, no more and no less. E-TTL II remains functional with *all* Canon EF lenses, but when using direct flash, E-TTL II is at its best when distance data is available.
    Last edited by iND; 07-24-2015 at 08:24 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •