Page 1 of 2 12 LastLast
Results 1 to 10 of 19

Thread: Flash Battery durability

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Senior Member
    Join Date
    Dec 2008
    Posts
    184

    Flash Battery durability



    I have a 580 EX Speedlite and I use Everready NiMH rechargeable batteries with it. I just went out with a fully charged battery set and was able to shoot only around 20 fill-in flashes with it before they died. The batteries are relatively new and I have 3 sets of them. I roughly get equivalent performance from all of them. I also have 2 chargers, one is a quick charger and the other takes around 8-10 hours for a full recharge.


    This morning's shooting was in cold conditions around 30F or -1C.


    Just wonder if this is typical with other users or do I have defective stuff. Any suggestions would be appreciated.


    I use to use nicads with my Speedlite 199A and got great durability.

  2. #2
    Senior Member
    Join Date
    Dec 2008
    Posts
    1,156

    Re: Flash Battery durability



    I have (essentially) four 580EX IIs. When I started with them, I used the Impact (perhaps B&H store brand?) AA NiMH rechargeables. Great power at 2900mAh, but newer batches seemed to go downhill in quality FAST. Some of the newer ones were duds right out of the carton, others went dead within a few charges. Since then, I've noticed that they leak down, as many NiMH batteries reportedly do. I can't say any have died as quickly as yours. I have about 10 sets of those.


    I recently got six sets of the Sanyo "Eneloop" batteries. Lower power at 2000mAh, but reportedly no leakdown. So far, they've definitely been VERY impressive.


    Regardless, I have the La Crosse BC-900 battery charger. Unless I'm seriously pressed for time, I always charge at 200mA; I suspect that's a big reason that all of my batteries have done as well as they have. I normally mark each set with an ID, and keep that set together through use and recharging.
    We're a Canon/Profoto family: five cameras, sixteen lenses, fifteen Profoto lights, too many modifiers.

  3. #3
    Senior Member
    Join Date
    Dec 2008
    Posts
    184

    Re: Flash Battery durability

    peety3:

    Thanks for your comments. I think mine were bad to start with or just died. I have 3 sets which I never mix. I don't think I've charged each of them more than a dozen times.

    This morning, I thought I'd do a test by pulling out a set of nicads and going to repeat what I did the other day. I got at least 60 shots out of them which was typical in the past. When they ran out I put in a set of NiMH and got about 3 shots. Yes THREE shots only.

    I think I'll have to find my other sets of nicads for the short term and look for a better brand of rechargeable AA's.

  4. #4
    Senior Member
    Join Date
    Dec 2008
    Posts
    1,156

    Re: Flash Battery durability



    Ouch. My charger shows me battery voltage when I first insert the battery. My Impact batteries are almost always at 1.20-1.25V, but some that sat too long in window 'candles' or in flashes have been in the low 1.1V range. However, some of the newer Impact batteries, either right out of the box or a few cycles later, have been showing up as -null-, which is the same as 'no battery'. That battery is officially dead then.
    We're a Canon/Profoto family: five cameras, sixteen lenses, fifteen Profoto lights, too many modifiers.

  5. #5
    Senior Member
    Join Date
    Dec 2008
    Posts
    133

    Re: Flash Battery durability



    i used SONY 2700amh it last 250 shots back up energizer E2 this will last 220++ shots

  6. #6
    Senior Member
    Join Date
    Dec 2008
    Location
    Melbourne, FL
    Posts
    1,246

    Re: Flash Battery durability



    I use Energizer E2 2500 in mine. Shooting at 1/1 inside of a soft box I probably get 80-100 shots out of it. I have a high speed charger that charges them in 15-20 minutes. I have about 32 in my bag for my 3 light system, two 580ex2s and one 430ex. In the 430 they last longer and if I use the the 580s at lower power they last substantially longer.

  7. #7
    Senior Member
    Join Date
    Dec 2008
    Location
    Vancouver, Washington, USA
    Posts
    1,956

    Re: Flash Battery durability



    Quote Originally Posted by peety3
    I recently got six sets of the Sanyo "Eneloop" batteries. Lower power at 2000mAh, but reportedly no leakdown. So far, they've definitely been VERY impressive.

    I second the Eneloops.

  8. #8
    Senior Member
    Join Date
    Dec 2008
    Location
    Flagstaff, AZ
    Posts
    162

    Re: Flash Battery durability



    Peety, the milliamp-hours are a measure of the life of the battery, not the power....


    But I am wondering if anyone has trouble with batteries not charging the flash capacitors right after you put them into the flash. I have the 430 EX II and some B&H brand 2900 mAh NiMH batteries and sometimes when I put them in the flash right after a charge, the pilot light doesn't ever come on. The charger is slow but has cool features like independent charge displays and stuff, but I wonder if I have a couple dead batteries (I only have 8 total) or the charger says they are charged but they are not.


    I shot a wedding and one set died right away and then the second set went for hundreds of shots. Anyone have this experience.

  9. #9
    Senior Member
    Join Date
    Dec 2008
    Posts
    1,156

    Re: Flash Battery durability



    Quote Originally Posted by Stephen Probert


    Peety, the milliamp-hours are a measure of the life of the battery, not the power....


    Yes and no. If you want to chase some technicalities and/or grill me on semantics, I'm ready.


    Regardless, I've had awful results with the B&H/Impact 2900mAh batteries. Older ones arrived more consistent, newer ones arrived with some dead cells upon arrival. Over the 2+ years I've had them, they've continued to go downhill - significant variations in the amount of energy needed to return them to a full charge, and several additional cells have died.


    Looking at the reason this thread started, my various comments come down to a common point: some brands are better than others, and if there's one or more bad batteries within a set, your flash might not work for long on that set. Using a rapid charger can have detrimental effects on your batteries. I recommend the La Crosse BC-700 chargers (cheaper than the BC-900, but I have two of each model) and the Sanyo Eneloop batteries (I have 48 of these and will be ordering more next month).


    We're a Canon/Profoto family: five cameras, sixteen lenses, fifteen Profoto lights, too many modifiers.

  10. #10
    Senior Member
    Join Date
    Dec 2008
    Posts
    184

    Re: Flash Battery durability



    I was able to get Sanyo Eneloop batteries and a charger locally, at Costco surprisingly. Right out of the pack, I was able to take at least 150+ shots with my 580EX before I had to recharge. I am totally impressed compared to the Eveready NiMH that lasted only around 20 shots after a 9 hour charge. I'm currently running down the pre-charge on my second set of Eneloops and the first set is ready to go again.


    Thanks for the great advice on the Eneloops.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •